
Add a fun pop of texture to any wall with these faux brick panels.
Why can’t garage walls be pretty too?
Okay, I know, I’m weird (this has already been established by anyone and everyone that’s ever seen my Instagram Stories), But I’ve made the decision to add faux brick to my garage wall.
Now that I’ve started DIYing and building I spend so much time in my garage and I can’t take the beige walls any longer. They need texture and beauty and some white paint to brighten uo the place.

This project isn’t difficult but it does require some arm strength or a helper, and a large car to transport the panels.

TABLE OF CONTENTS (click to jump ahead)
BEFORE PICTURE
Here is the very sad and bland before picture of the wall I’m working on.

PREP AND SUPPLIES
TIME: 5-6 hours
COST: $140 (dependent on size)
DIFFICULTY: Medium
To complete this project, you’ll need a few supplies. The biggest issue you may run into is getting these big boards from the store to your home. Keep in mind you can always ask the big hardware stores to cut your wood for you.
Lumber
- 1/2”x4’x8’ sheet of Sande Plywood cut to desired size
- Scrap wood (for Furring strips)
- 1” Dowels
HOW-TO STEPS
STEP 1: PLAN YOUR SPACING
First, measure out and plot your spacing for your DIY Pegboard. These are pretty heavy so try to plan it out with as many wall studs as possible.

STEP 2: MEASURE AND MARK HOLES
Decide on your desired peg spacing and mark your lines. I found it helpful to start on the center line and see how many could evenly fit.


TIP
To complete this project, you’ll need a few supplies. The biggest issue you may run into is getting these big boards from the store to your home. Keep in mind you can always ask the big hardware stores to cut your wood for you.
STEP 2: DRILL HOLES
Use your Forstner bit to drill holes
Next, drill slow steady and straight. Drilling too fast will wear out your bit, and drilling at any sort of an angle will prevent the pegs from sitting correctly. (Your arms will be really sore by the time you’re done.)

TIP
Be sure to drill through the side that will be visible. The pressure form the bit will cause tear out on the last layer of plywood. You can avoid this by covering the back side with tape or drilling half way through the front then half way through the back.
But since the back is not visible who has the time or patience for that?


TIP
After completing a few rows of holes, stack the board on top of the other board as a template for your holes.
This will save you time to not have to draw out every single line.
Screw in Pegboards
Using a level, drill cabinet screws through the peg boards into the furring strips.

STEP 4: INSTALL PEGBOARD
Attach Furring Strips
Furring strips are just pieces of wood that help the peg board sit off the wall, so pegs have room to slide in. Use long cabinet screws to install strips of wood into studs along the top, middle and bottom; just make sure they are spaced out correctly where they won’t block the holes.

STEP 5: FINISH AND DECORATE
Sand and Stain or Paint
Finally, you can paint or stain your pegboard however you choose. Cut some 1″ dowels and style your DIY pegboard however you choose! I love this because it can be changed and adapt to whatever your future needs may be.


DIY GIANT PEGBOARD REVEAL
